Speaker Selector

Discussion in 'DIY Discussion' started by Tommyboy68, Jul 14, 2016.

  1. Tommyboy68

    Tommyboy68

    Joined:
    Jul 14, 2016
    Messages:
    1
    Likes Received:
    0
    This seems like too simple of a question for those on this forum but here it goes. I have a boat with Alpine stereo and Alpine APX 450 amp. I am adding wake board tower speakers but want to be able to select between the rear speakers in the boat and the wake board speakers. it seems like there should be a simple selector switch to be able to do this, but I am not having much luck. Is there a simple switch I could use or do I need to go with a zone type system. Also some zone selectors are 100 watts per channel, do I need one that supports more if I have to go this route to match the amp??
     
    Tommyboy68, Jul 14, 2016
    #1
    1. Advertisements

Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.